Made from aircraft aluminum, JOES quick disconnects are pin-less and spring-loaded for fast steering wheel removal. The splined steel coupling is bored to slip over a 3/4" steering column. Fits industry standard large 3 hole pattern. 3x 5/16" on a 1-3/4" Bolt Circle.
1 SWITCH DOES IT ALL!
DOWN is off
MIDDLE is Ignition On
UP is momentary start
Comes pre-wired with color coded harness, flip up switch cover. Simple to install.
The On/Off switch is a twin contact battery isolation switch that will ensure complete electrical isolation of the vehicle when it is switched off, so it cannot be re-started.
This Lucas style battery cut out switch is made in the same `Lucas` style as the switch that has been used by generations. A twin terminal design with a ceramic base, metal body and T-bar style switch.
Castrol Response DOT 4 brake fluid is specially formulated to meet the demanding requirements of modern high performance brake and clutch systems with the exception of vehicles with mineral oil systems.
Castrol Response has a boiling point of 265 degrees celcius which enables the fluid to operate at a high level throughout its service life, offering system protection together with ultimate braking confidence. It is recommended that the brake fluid is to be changed every two years to optimise braking performance.
These solid-state technology electronic fuel pumps provide outputs up to 132.5 liters/hour and .68 bar. Facet/Purolator Cube Fuel Pumps are self-priming with a dry lift capacity of 120 inches. Two universal models provide complete coverage for all low and high-pressure carburetor applications for cars, vans, RV’s, and light trucks, in addition to many diesel applications. All models of the Facet/Purolator Cube Fuel Pumps are compatible with gasoline, diesel, biodiesel, blended alcohol fuels, and fuel additives.
Specification:- Fast Road
Pump:- 40106
Voltage:- 12v
Earth:- Neg
Pressure (Psi):- 4.0-7.0
Flow:- US Gallons/Hr 32
Dry Prime Height in Mtrs:- 0.3
Thread Size:- 1/8th nptf
Average Run Time or MTBF:- 6000 hrs
Fuel Union Installation:- When fitting fuel unions, either wrap PTFE tape around the threads or use Loctite 243 to create a fuel proof seal